Diamond grinding point cylindrical slim dia. 14x0.5 mm shank dia. 3 mm D64 (fine) for grinding grooves

Technical information

Dia. external

14 mm

Dia. shank

3 mm

Grit size

D 64

Length, shank

35 mm

Width

0.5 mm

Packaging unit

1 piece

Description

• Electroplated diamond and CBN grinding points are used for both wet and dry grinding.
• The special shape ZY is suitable for grinding slits and grooves in hard-to-reach areas.
• N = non-stepped shank

Recommendations for use

• Application is possible for both dry and wet grinding. If possible, wet grinding is to be preferred in order to reduce tool wear and the risk of thermal damage.
• Generally, the following applies: For optimum economic efficiency, select a grit size that is as coarse as possible and as fine as necessary. Influencing factors include the hardness of the material and the surface quality required.
• Loaded tools can be cleaned using ultrasound. In the event of strong contamination on the coating, please clean using the sharpening block DSB 2005025 (EAN 4007220168332).
• Select as large a tool diameter as possible, as this increases the amount of grit that engages the workpiece. For internal grinding, the maximum tool diameter is 3/4 of the diameter to be ground.
• The longitudinal feed rate for internal grinding must not exceed 2/3 of the total width per workpiece rotation. The infeed depends on the material to be machined, the cutting speed, the stability of the tool, its holder and the tool drive.
• Because of the monolayer coating, the drive spindle and tool mounting must have a high concentricity. The finer the grit size used, the more accurate the concentricity needs to be.
• The tool drive must have sufficient drive output on the grinding spindle to ensure the required rotational speed, even under load.
• Dry grinding: 8–18 m/s
• Wet grinding: 15–25 m/s

Ordering notes

• Customer-specific tool solutions are available on request.

Product identifiers

Product number

36051406

Family SKU

177255

EAN

4007220353257